Table of Contents
Advertisement
Quick Links
AIR BRUSH COMPRESSOR
ASSEMBLY and OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd. / Camarillo, CA 93011
®
Copyright © 1997 by Harbor Freight Tools
. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in any
shape or form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Central Pneumatic 34844
Summary of Contents for Central Pneumatic 34844
- Page 1 AIR BRUSH COMPRESSOR ASSEMBLY and OPERATING INSTRUCTIONS ® 3491 Mission Oaks Blvd. / Camarillo, CA 93011 ® Copyright © 1997 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
- Page 2 Do not use a tool for a purpose for which it was not intended. 7. DRESS PROPERLY. Do not wear loose clothing or jewelry as they can be caught in moving parts. Non-skid footwear is recommended. Wear restrictive hair covering to contain long hair. Page 2 -- SKU: 34844 REV 10/04...
- Page 3 Do not allow compressor to sit pressurized for longer than one hour. 19. Make sure that regulator is set at least 10 PSI lower than the lowest rated piece of equipment you are using. Page 3 -- SKU: 34844...
- Page 4 Always inspect extension cords for any damage. If there are any loose, frayed or exposed wires, damaged insulation, or defective connections, replace the cord. Harbor Freight Tools can supply UL listed and outdoor rated cords in multiple AWG ratings if needed. Page 4 -- SKU: 34844...
- Page 5 Step 1:Remove the contents of the box and place on a clear work area. Step 2:Place the JET PEN HOLDER (#10) onto the end of the HANDLE (#9) as shown in Figure 1. Figure 1 — Placing the Jet Pen Holder Page 5 -- SKU: 34844...
- Page 6 Step 1:Connect your air brush to the Brass Fitting at the end of the AIR CONDUIT (#7). Tighten as appropriate. Step 2:Plug the Power Cord into an appropriate outlet. Step 3:To operate the Air Brush Compressor, flip the Switch to the ON or “l” position. Page 6 -- SKU: 34844...
- Page 7 There are no user-serviceable parts in your Air Brush Compressor. If you need service performed on your Compressor, please return it to Harbor Freight Tools. PARTS LIST Item# Description Item# Description Compressor Handle Air Conduit Jet Pen Holder Air Inlet DIAGRAM Page 7 -- SKU: 34844...
Need help?
Do you have a question about the 34844 and is the answer not in the manual?
Questions and answers