Loading A Roll Of Labels; Changing A Label Roll; Removing The Old Roll - CardioChek 2750 User Manual

Loading a Roll of Labels

Prepare the roll of labels
1. Remove the sticker from the beginning
of the roll of labels.
Note: Make sure there is a black sensor
mark on the label backing.
2. If needed, cut between the labels to
create a "leader. "
3. If the end of the roll is not prepared as
shown above, cut between the labels
leaving as much backing as possible.
Load the roll of labels
WARNING: DO NOT THROW SPINDLE AWAY
WHEN CHANGING LABEL ROLLS
1. Make sure the power cord is connected and the printer
is turned on. The green status light should be flashing.
2. Press the left and right side of the label cover and lift
up the edge of the label cover to open.
3. Remove the spindle from the printer and insert the
label roll on the spindle.
4. Insert the labels and spindle into the printer. If
necessary, adjust the guides to fit the labels as
shown below.
5. Insert the free end of the label roll, label side down,
into the paper inlet slot. Push the label stock into
the paper inlet slot until you feel a slight resistance.
Continue pushing gently. The printer automatically
feeds the labels through and aligns the end in the
exit slot.
If the label end doesn't appear through the slot:
Press and release the form feed button to advance
the labels.
6. Close the label cover.
Roll Waste Roll
Prepared end Cut here
Label Cover
Spindle
Label Guides
6
Close Label Cover

Changing a Label Roll

WARNING: DO NOT THROW SPINDLE AWAY WHEN CHANGING LABEL ROLLS
This procedure describes how to remove and replace label rolls.
• When you run out of labels, the green status light on the front of the printer flashes.

Removing the Old Roll

CAUTION: DO NOT pull on the labels to remove them from
the printer. This may cause labels to get stuck inside the printer.
1. Tear off any printed labels. If labels aren't torn off, they may get jammed when you
perform step 2.
2. Press and hold the form feed button. The labels will reverse out of the printer. If this does
not work, see "Adjusting the Position of Labels" to release the platen to remove the labels.
7