Fcc Compliance Statement; Installation - CardioChek 2750 User Manual

Contents
CardioChek
CardioChek Printer
Printer Label Roll
CardioChek
CardioChek Plus
Printer
USB Printer
User Guide
Connection Cable

Installation

For best performance, we recommend that you install your CardioChek printer on a flat
surface in a location that satisfies the following environmental conditions:
• Not subject to vibration
• Not exposed to direct sunlight
• Dust-free
• Condensation-free
• Temperatures: 59 to 95°F (15 to 35°C)
• Humidity: 30% RH to 80% RH (non-condensing)
CardioChek Printer
Power Supply
CardioChek PA Serial
Connection Cable
(May also be used with
CardioChek Plus
analyzers.)
2

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by PTS, Inc. could void the user's authority to
operate the equipment.
Applicable EC Directives and Standards
Directive Title
2004/108/EC EC Electromagnetic Compatibility Directive
2006/95/EC EC Low Voltage Directive
2009/125/EC Directive on Eco-Design of Energy-related Products
2011/65/EU Restriction of the use of certain hazardous substances (RoHS) Directive
Standards
EMC EN55022 class B
EN61000-3-2, EN61000-3-3
EN55024
LVD EN60950-1
RoHS EN50581
11