Removing Stuck Labels - CardioChek 2750 User Manual

How to Set Up the CardioChek Analyzers for Printing
CardioChek PA Analyzer
1. If the analyzer is off, press either button to turn on the analyzer. Wait for the display to
read INSTALL MEMO CHIP or INSERT STRIP.
Note: If RUN TEST is displayed, go to Step 3.
2. Ensure both power supply and communication cables are connected.
3. Press Next. The display will read RUN TEST.
4. Press Next until USER SET is displayed.
5. Press Enter. PRINT is displayed.
6. Press Enter. MEDIA is displayed.
7. Press Enter, or Next then Enter to select L (LABEL) and return to P (PAPER) MEDIA.
8. Press Next, then press Enter to display COPIES.
9. Press Next to display 01, 02, or 03 copies.
10. Press Enter to accept the desired number of copies and return to COPIES.
11. Press Next, then press Enter to display OUTPUT.
12. Press Next until PRINT A is displayed.
13. Press Enter to select and return to OUTPUT.
14. Press Next. TEST is displayed.
15. Press Enter for a sample printout.
4

Removing Stuck Labels

If a label becomes stuck in your printer, remove it as follows:
1. Make sure that the printer is turned off. If the Status Light is on, hold the Power Button until
the printer is turned off.
2. Swivel the Roll Cover open. With a pair of scissors, cut the label stock between the label roll
and the paper inlet slot.
3. Remove the Print Engine Cover by pulling it toward you while pressing the left and right side
of the Print Engine Cover.
4. Release the pressure on the label stock by moving the Platen Release Lever forward. When you
let go of the Platen Release Lever, it goes back to the original position. Hold the Platen Release
Lever until a label is removed.
5. Remove the stuck label.
CAUTION: DO NOT touch print engine. It may be hot.
6. Return the Platen Release Lever to the original position.
7. Replace the Print Engine Cover, starting at the bottom, and push the top edge forward until
the Print Engine Cover snaps into place.
9