Switching On And Off; Switching On The Control Unit; Switching On The Laser Head - Domino F Series User Manual

Switching On and Off

WARNINGS:
CAUTION: The lens cap must be removed before operation.

Switching On the Control Unit

Turn on the laser unit F220i first by switching the switch from position
"0" to "1". At the control panel, release the On/Off button by turning it
clockwise. Wait until the SERVER RUNNING
illuminated.

Switching On the Laser Head

Turn the key switch from position "0" to position "1". To start the laser
turn the key clockwise to the laser symbol and hold it for at least 1
second. The key automatically turns back to position "1".
• The laser needs a warm-up phase of 3 seconds.
The PRINTER BUSY
hardware is switched on.
The PRINTER READY
Dynamark 3 software and starting the lasers, the marking system is
ready.
Laser emission is also displayed by a red LED on the rear of the laser
unit.
30
(1) The laser marking system must only be used
for its intended purpose.
(2) The laser marking system may only be
operated by trained personnel.
(3) Operation is only allowed with all required
cables connected and all parts mounted. Do
not disconnect any cables during operation.
indicator will illuminate when the laser
indicator illuminates. After initialising the
indicator has