Laser Marking Process - Domino F Series User Manual

Laser Marking Process

Potential fire risks could result from examples as listed below. This list
is not considered to be complete. Local conditions must be considered
as well.
• Printing on not specified material (e.g. easily inflammable or
explosive materials).
• Invalid parameter settings (e.g. very low mark speed).
• Invalid parameter settings due to corrupted print data.
• Printing constantly on the same product (e.g. no product movement
caused by various reasons).
• Inflammable gases or materials inside the working area.
• In printing mode the laser beam is controlled by software which
must be considered as part of the risk assessment.
• Install a fire detector near the laser to monitor the marking process.
16