EcoMotion CORE Pro + eFAT User Manual page 25

Problem
Motor runs without
using TAG / PAS
systems
TAG system doesn't
work
Motor make a
"drilling" noise and
reduce power /
shuts off
Charger doesn't
charge the battery
Charger shows s
full charge in an
unusually short
amount of time
Charger indicator
light flashes and not
change into red (not
charging)
Bicycle has
intermittent power
EcoMotion Bikes
Possible cause
Faulty PAS sensor
Faulty throttle
Wire short
Faulty controller
Motor shutdown
system operated
Faulty throttle
Faulty controller
Throttle button not
pressed in
Display rupture wire
Low battery
Motor gear
damaged
Burnt fuse
Faulty charger
Outlet has no power Check a different outlet
Faulty charger
Battery lifetime is
over / shortened
Faulty charger
Loose connector
Loose fuse
Damaged wires
Solution
Replace sensor and
retest
Replace throttle and
retest
Replace main cord and
throttle cord and retest
Replace controller and
retest
Make sure that bake
handles in their place
Replace the throttle
and retest
Replace controller and
retest
press in the shutdown
button
Replace the display
and test
Charge the battery full
charge
Replace motor gears
Replace the fuse
Replace the charger
Replace the charger
Replace the battery
Replace the charger
Check all connectors
Check fuse connector
Inspect all wires
25