Shear Pin Replacement; Belt Guide Adjustment - Snapper 8526, 9528, 10530, 11532 Operator's Manual

SHEAR PIN REPLACEMENT

WARNING
Do not go near the discharge chute or auger
when the engine is running. Do not run the engine
with any cover or guard removed.
Under most circumstances, if the auger strikes an object
which could cause damage to the unit, the shear pin will
break. (This protects the gear box and other parts from
damage.)
The shear pins are located on the auger shaft as shown
in Figure 23. To replace the shear pins, tap out the bro-
ken pin with a pin punch, and install a new shear pin and
cotter pin. Do NOT replace shear pins with anything
other than the correct grade replacement shear pin.
(Use of bolts, screws or a harder shear pin will lead to
damaged equipment.)

BELT GUIDE ADJUSTMENT

1. Disconnect spark plug wire.
2. Remove screw (B, Figure 21) from belt cover (A).
Remove belt cover (A).
3. Measure the distance between the belt guide (B,
Figure 24) and the belt (D). The distance should be
1/8 inch (3.18mm).
4. If adjustment is necessary, loosen belt guide cap-
screw (C). Move belt guide (B) to correct position.
Tighten capscrew (C).
6. Reinstall belt cover (A, Figure 21) securing with
screws (B).
7. Reconnect spark plug wire.
Adjustments & Service
A
B
Figure 23. Shear Pins
A. Shear Pins
B. Cotter Pins
A
Figure 24. Belt Guide
A. Idler Pulley (Engaged Position)
B. Belt Guide
C. Capscrew
D. Belt
27
B
A
C
B
1/8" (3.18mm)
D