Cleaning / Maintaining The Machine - Kompernass Bifinett Edition KH 1177 Operating Instructions Manual

KH1177_IB_EU.qxd 10.01.2006
Lasagne (Fig. ¸):
Spaghetti (Fig. ¹): Front rollers / dough
Taglierini (Fig. ¹): Front rollers / dough
Tagliatelle (Fig.
If the cutting rollers do not cut the
dough, this means that the dough is
too soft. In this case, we recommend
adding some flour to the dough and
running it through the smoothing
rollers again.
However, if the dough is too dry and
is not "gripped" by the cutting
rollers as a result, you can add some
water and run the dough through
the smoothing rollers again.
During use, the edges beneath the
rollers should be cleaned periodically
with a kitchen towel.
• Then lay the noodles on a kitchen
towel and let them dry for at least
one hour. You can store the dough
products for up to 1 - 2 weeks if they
are kept in a cool and dry place and
covered with a kitchen towel.
• Then place the noodles in a sufficient
amount of salted, boiling water (about
4 litres per 1/2 kg of noodles). Fresh
noodles are ready within 2 - 5 minutes,
depending on the thickness of the
dough. While cooking, stir carefully,
then drain the noodles in a colander.
11:03 Uhr
Smoothing rollers /
dough rolled in
adjustor position 9
rolled in adjustor
position 4
rolled in adjustor
position 9
):Middle rollers /
dough rolled in
adjustor position 5 - 9
Seite 13
8. Cleaning / maintaining the
machine
• Always remove the motor
before cleaning the machine (use the
crank to turn the rollers).
• Pull the plug out of the socket before
cleaning the motor or before starting
maintenance on the machine! Clean
the motor exclusively with a lightly
moistened cloth.
• To remove the cutting unit from the
machine, lift it up and pull it out
along the smoothing rails. To attach
the cutting unit to the machine (Fig.
), follow the above steps in reverse.
• The machine must never be cleaned
under flowing water or in a
dishwasher! (Fig.
• To clean the machine after use, you
can use a brush and a small wooden
stick (Fig. ).
Never clean the rollers with a knife
or run a cloth through them! The
appliance could be damaged beyond
repair.
• After use, always store the machine
and its accessories in the original
packaging.
• Repairs to the electric machine com-
ponents may only be performed by
specialised experts.
• If necessary, lubricate the ends of the
cutting rollers with some vegetable
oil (Fig. ).
- 13 -
KH 1177
first
).