Installation Instructions; Tools You Will Need; Materials You Will Need - GE GTDL740EDWW Installation Instructions Manual

Dimensions and installation information (3 pages)

Manual (86 pages)

Technical service manual (54 pages)

Table of Contents

Available languages

Minimum clearance from combustible surfaces and for air opening are: 0 in. clearance both sides, 3 in. front, 7 in. top and 3 in. rear.

Consideration must be given to provide adequate clearance for installation and service

TOOLS YOU WILL NEED

(X2)

10" ADJUSTABLE WRENCHES

8" PIPE WRENCH

SLIP JOINT PLIERS

FLAT BLADE SCREWDRIVER

Step 1 Verify your gas installation (see section 2).

Step 2 Prepare the area and exhaust for installation of new dryer

(see section 1).

Step 3 Check and ensure the existing external exhaust is

clean (see section 1) and meets attached installation

Step 4 Remove the foam shipping pads (see section 1).

Step 5 Move the dryer to the desired location.

Step 6 Level your dryer (see section 8).

Step 7 Connect the gas supply (see section 3) and check for leaks

(see section 4).

Step 8 Connect the external exhaust (see section 7).

Step 9 Connect the power supply (see section 5).

Step 10 Check the operation of the power supply, gas connections,

and venting.

Step 11 Place the owners manual and the installation instructions

in a location where they will be noticed by the owner.

For alcove or closet installation, see section 9.

For bathroom or bedroom installation, see section 10.

For mobile or manufactured home, see section 11.

For side or bottom exhaust, see section 13.

For connecting inlet hoses, see section 14.

For garage installation, see section 12.

For door reversing instructions, see section 15.

1" = 2.5 cm

1' = 0.3 m