Setup Procedures; Quick Setup List - Snapper 3190E Dealer Setup & Adjustment Instructions Manual

Quick Setup List -

Page Setup Procedure
4 Unbox & Assemble
5 Fill Gas Tank
6 Adjust Auger Cable
6 Test Run
4/2003
319 Single Stage Snowthrower
Steps to Perform
❏ Remove Unit From Box.
❏ Install Discharge Chute
❏ Assemble Handle Bars
(Be careful not to pinch the auger cable)
❏ Fill Gas Tank
❏ Adjust auger Cable
❏ Check Primer
❏ Check Choke
❏ Check Recoil Starter
❏ Check Electric Starter (Where Applicable)
❏ Check Auger Control Cable
❏ Check Kill Switch
❏ Check Chute Rotator
❏ Check Deflector
3
TP 300-3862-00-SW-S