Hand Belt (HA-R93HB)
The hand belt (HA-R93HB) is used attached to the IT-G400.
Attaching the Hand Belt
Use the procedure below to attach the hand belt.
1. Fit the scanner end mount of the hand belt
onto the scanner section of the IT-G400.
2. Fit the lower end mount of the hand belt onto
the bottom of the IT-G400.
Tip!
Adjust the belt to a convenient length (so that
the end of the hook and loop fastener is level
with the guide line) before mounting it onto
the IT-G400.
Scanner end mount
(The end where the belt
is split into two straps)
Hook and loop fastener
Belt
Lower end mount
Guide line
Align the IT-G400
with the mount
and push the
scanner end fully
into the mount.
Align the IT-G400
with the mount
and push the
bottom end fully
into the mount.
E-49