Elite Screens Insta-RP2 Screen Series Installation Manual

Self-adhesive rear projection screen film

Insta-RP2 Screen Series

Self-Adhesive Rear Projection Screen Film

PRECAUTIONS

1. This product is an adhesive rear-projection screen that can be applied to various surfaces such

as transparent glass or acrylic.

2. This product is made for a one-time application. It has a non-reusable adhesive that bonds

firmly to a window surface. If the window has any layer treatment such as tinting, it is likely

that the layering will be damaged upon removal of the screen.

3. To ensure an even and "bubble-free" installation, make sure that the window surface is clean

and evenly moistened previous to installation.

4. Do not fold the Insta-RP2 Screen's material. Folding will result in a permanent crease that

cannot be removed.

5. Avoid touching the screen with any hard or sharp objects that may cut, scratch or otherwise

deface the material.

6. The Insta-RP2 Screen is applied to a moist surface. This can impact the installation of the

material by possibly creating slight ripples or bubbling. These will disappear within the first few

weeks as the micro-droplets of water trapped in the adhesive evaporate.

Contents of this package

Please make sure that all parts listed below are included. Contact Elite Screens Immediately if anything is

missing.

a .

a. Insta-RP2 Screen Material

b. Microfiber cleaning cloth

Installation Guide

Pad

b .

Parts List

QTY

Table of Contents

Do you have a question about the Insta-RP2 Screen Series and is the answer not in the manual?

Page 1 These will disappear within the first few weeks as the micro-droplets of water trapped in the adhesive evaporate. Contents of this package Please make sure that all parts listed below are included. Contact Elite Screens Immediately if anything is missing. Parts List a.
Page 2 Installation 1. Use a spray bottle filled with water and a mild detergent (1:1000 ratio column) 2. Thoroughly clean the glass surface using the correct glass-cleaning equipment 3. Make sure that the glass surface is smooth (unblemished) and perfectly flat. 4.
Page 3 9. Use of a leveling brush or scraper will eliminate the residual moisture and make sure that the material has been applied properly. 10. Allow material to stand unused for 2 to 3 hours to allow the adhesive to bond and set. For a local Elite Screens contact or Technical Support, please visit www.elitescreens.com...