Panasonic SC-HC402 Operating Instructions Manual page 12

Display
Press [DISPLAY] to change the display.
The information will scroll through the display.
Each time you press the button:
Dynamic label:
PTY display:
Ensemble label:
Frequency display:
Time display:
Automatic clock adjustment
If the DAB/DAB+ broadcast includes time information,
this unit's clock will be automatically updated.
1
Press [RADIO MENU] repeatedly to select "AUTO
CLOCK ADJ".
2
Press [2, 1] to select "ON ADJUST" and then
press [OK].

≥ Select "OFF ADJUST" to turn the automatic clock adjustment
function off.
To verify or improve the signal
reception quality
To check the signal reception quality, at least 1
frequency block needs to be successfully memorised.
≥ If "SCAN FAILED" is displayed after "DAB+" is
selected or after an auto scan, proceed to "Manually
tuning 1 frequency block" (l below)
≥ If stations have already been memorised to this unit,
proceed to "Checking the DAB/DAB+ signal
reception quality" (l right)
∫ Manually tuning 1 frequency block
Use this function to scan 1 frequency block after
adjusting the position of the DAB antenna.
Preparation
Note down a frequency block that can be received in
your region (e.g., 12B 225.648 MHz).
1
While "SCAN FAILED" is displayed.
Adjust the position of the DAB antenna.
2
Press [RADIO MENU] repeatedly to select
"MANUAL SCAN".
3
Press [2, 1] to select the frequency block that is
receivable in your region and then press [OK].
12
TQBJ0987
Information about the
broadcast
Programme type
The name of the ensemble
The frequency block and
frequency is displayed.
Current time

≥ If broadcasting stations are memorised, proceed to
"To re-scan DAB/DAB+ stations" to memorise stations on
other frequency blocks. (l 11)
≥ If "SCAN FAILED" is still displayed, repeat steps 1 to 3 until a
station is memorised. If the situation does not improve, try
using an outdoor DAB antenna or consult your dealer.
∫ Checking the DAB/DAB+ signal
reception quality
1
While listening to the DAB/DAB+ broadcast:
Press [RADIO MENU] repeatedly to select
"SIGNAL QUALITY" and then press [OK].
≥ The current frequency block is displayed and
then the reception quality is indicated.
Reception quality
0 (poor) – 8 (excellent)
2
If the signal reception quality is poor, move the
antenna to a position where the reception quality
improves.
3
To continue checking the quality of other frequency
blocks:
Press [2, 1] again and select the desired
frequency.
4
Press [OK] to exit.

≥ If the antenna has been adjusted, perform auto scanning and
update the station memory. (l 11)