With kind regards Your Beurer team Why use a daylight lamp? When the hours of daylight are noticeably decreased in autumn and people increasingly stay inside, the effects of a lack of light may cumulate.
IP21 Protected against foreign objects The CE labelling certifies that the product com- equal to or greater than 12.5 mm plies with the essential requirements of Directive in diameter and against vertically 93/42/EEC on medical products. falling drops of water. IP22 Protected against foreign objects Date of manufacture...
Repairs Important • Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju- ries. Failure to observe this regulation shall void the warranty. • If you need to have the unit repaired, contact customer service or an authorised dealer. 4.
Enjoying the light Sit as close as possible to the lamp, between 20 cm and 60 cm. You can go about your normal activities while using it. You can read, write, make telephone calls, etc. • Every so often, briefly look directly into the light, since the effect results from the eyes/ retina receiving the light.
If you need to have the unit repaired, LEDs faulty. contact customer service or an author- ised dealer. 11. Technical specifications Model no. TL 30 Type WL 11 Dimensions (WHD) 236 x 156 x 20 mm (26 mm incl. storage slot) Weight 175 g (260 g incl.
Model no. Input 100–240 V ~ 50/60 Hz Output 12 V DC, 650 mA, only in connection with TL 30 Protection The device is double protected and therefore corresponds to protection class 2. Polarity of the the DC voltage connection...
ELECTROMAGNETIC COMPATIBILITY INFORMATION Technical Description Concerning Electromagnetic Emission Table 1: Declaration - electromagnetic emissions Guidance and manufacturer’s declaration - electromagnetic emissions The model TL30 is intended for use in the electromagnetic environment specified below. The customer or the user should assure that it is used in such an environment. Emissions test Compliance Electromagnetic environment –...
Page 9
Technical Description Concerning Electromagnetic Emission Table 1: Declaration - electromagnetic emissions Guidance and manufacturer’s declaration – electromagnetic immunity The model TL30 is intended for use in the electromagnetic environment specified below. The customer or the user should assure that It is used in such an environment. Immunity test IEC 60601 Compliance...
Page 10
Table 3: Guidance & Declaration - electromagnetic immunity concerning Conducted RF & Radiated RF Guidance and manufacturer’s declaration – electromagnetic immunity The model TL30 is intended for use in the electromagnetic environment specified below. The customer or the user should assure that it is used in such an environment. Immunity test IEC 60601 Compliance...
Page 11
Table 4: Recommended separation distances between portable and mobile RF communications equipment and the model TL30 Recommended separation distances between portable and mobile RF communications equipment and the model TL30 The model TL30 is intended for use in electromagnetic environment in which radiated RF disturbances is controlled.
Need help?
Do you have a question about the TL 30 and is the answer not in the manual?
Questions and answers