Table of Contents
Advertisement
2 Installation and startup
2.1 Mounting the case
The housing is fixed to the wall with two
screws, which are screwed diagonally
through the holes marked with "wall".
The heads of the screws should be
maximum 6 mm in diameter so that the
cover is not screwed as well.
2.2 Opening the case
To deactivate the write protection the housing cover can be opened by removing the
metal screws above at the left and below at the right. The unprotect pushbutton is then
accessible from outside; the unit is unprotected by pressing this button.
Use a suitable adhesive seal to prevent the housing from being opened unnoticed.
2.3 Connecting
The following picture shows a typical installation including the PadPuls M1:
PC
PadPuls M1 User Manual
GmbH, Stettiner Str. 38, D-33106 Paderborn
D=6
Wall
67
46
D=5
Housing
PadPuls M1
- Bus
26.09.01, Version 1.3
D=5
Housing
all dimensions in mm
D=6
Wall
80
88
98
Pulse-generator
3
m
3
Advertisement
Table of Contents
