Relay PadPuls M1 User Manual page 10

Multiplicator
Unit
Counter
State
Write protection
Permanent error
Write protect
Read
Write
10 26.09.01, Version 1.3
GmbH, Stettiner Str. 38, D-33106 Paderborn
is the pulse increment (multiplicator) of the connected meter. For
each registered pulse the device adds "multiplicator" to the counter.
The numerator can take values between 0 (no counting) and 255,
the denominator between 1 and 255.
is the physical unit of the counter and of the pulse increment. All
proper units including variants with power of ten from the DIN EN
1434-3 are offered in the selection list.
is the accumulated counter. It has to be related to the unit
mentioned above. The counter can be programmed equal to the
counter of the connected meter in a range of 0 to 0 to 1x10
detail 1.099.511.627.775 ( = 00 FF FF FF FF FF hex.).
is the M-Bus state in hexadecimal notation.
is marked, if the device is protected against programming. Then
you cannot configure the adapter. The protection can be removed
after opening the sealable front cover of the housing and pressing
the "Unprotect" pushbutton.
is insignificant for the PadPuls M1.
Transmits a command to the PadPuls M1 to activate write
protection. The PadPuls then allows no further configuration. It is
protected against unnoticed manipulation.
reads the M-Bus device and refreshes the data on the selected
sheet.
sends the current options to the pulse converter, which stores this
data into the battery buffered memory. The PadPuls M1 changes
the options only if the write protect is deactivated. It is
recommended to read the data after writing and check it.
12
PadPuls M1 User Manual
or in