Table of Contents
Advertisement
debugging
terminal debugging
terminal trapping
terminal logging
The console of the master neither time out nor output any information. To return to the console of the
master, execute the quit command. The master is therefore reactivated and is ready for outputting
information.
Examples
# Redirect to member 2.
<Sysname> system-view
[Sysname] irf switch-to 2
<Sysname-Slave#2>
irf-port
Syntax
irf-port member-id/port-number
undo irf-port member-id/port-number
View
System view
Default Level
3: Manage level
Parameters
member-id/port-number: IRF port number, where, member-id represents the member ID of the device
in the IRF, which you can display with the display irf command. The port-number argument specifies
the port number, and the value can be either 1 or 2.
Description
Use the irf-port command to create an IRF port and enter IRF port view. If the IRF port is already
created, use this command to enter IRF port view.
Use the undo irf-port command to delete the specified IRF port.
By default, no IRF port is created on the device.
When an IRF port is created, you must bind physical IRF port(s) to this IRF port, and then the IRF
port is available for the IRF virtual device.
Related commands: port group interface.
Examples
# Create IRF port IRF-port 1 for the device with member ID 3, and bind this port to physical IRF port
Ten-GigabitEthernet 3/0/25.
<Sysname> system-view
1-15
Advertisement
Table of Contents
