End Debugging Mode - IDEC HG4F Basic Tutorial

2.
Double-click the Value cell for
device address D 10 .
Up and down buttons are displayed.
3.
Click [
press [Enter].
In this example, the value is 5 .
The value will be displayed in the
[Numerical Target] numerical input field
on the Operator Interface.
If the value does not display in the numerical input field, check the
devices for the [Numerical Target] numerical input field.
(Refer to " Numerical Target input field" on page 30.)

End Debugging Mode

Once debugging is complete, exit debug mode.
Click the
ging) icon.
] to set the value and
(Stop Debug-
www.IDEC.com/software
Chapter 5 Verify Operation
5
41