Simulating - IDEC HG4F Basic Tutorial

Simulating

1.
Press the [START] button.
The pilot lamp turns on.
2.
Press the [STOP] button.
The pilot lamp turns off.
3.
Press the [SET UP] button.
The [Numerical Target Setting Screen]
appears.
4.
Press the Numerical input.
The numeric keypad appears.
5.
Enter 100 , and press the [ENT]
key.
100 is set in [Numerical Target].
6.
Press the [Back to the Operating
Screen] button.
The [Operating Screen] appears, and
100 is displayed in [Target].
7.
Press the [SET the results] button.
Every time this button is pressed, the
value displayed in [Results] increments
by one.
www.IDEC.com/software
Chapter 5 Verify Operation
5
37