Maintenance; Motor Seal; Blades, Plates And Dicing Grids; Grating Discs - Robot Coupe CL 60 E Operating Instructions Manual

I M P O R T A N T
Check that your detergent is suitable for
cleaning plastic parts. Some washing agents
are too alkaline (e.g. high levels of caustic
soda or ammonia) and totally incompatible
with certain types of plastic, causing them to
deteriorate rapidly.

MAINTENANCE

• MOTOR SEAL

The motor seal on the shaft should be lubricated
regularly using a food safe lubricant.
In order to keep the motor completely watertight,
it is advisable to check the motor seal regularly at
6 month intervals for wear and tear and replace if
necessary.
The motor seal can be easily replaced without
having to remove the motor, so we strongly advise
you to ensure that is in good condition.

• BLADES, PLATES AND DICING GRIDS

The blades on all our discs are wearing parts that
need to be replaced from time to time, in order to
maintain consistently high cutting quality.

• GRATING DISCS

Grating discs deteriorate over time. We recommend
you replace them from time to time, in order to
maintain consistently high cutting quality
TECHNICAL
SPECIFICATIONS
• WEIGHT (Lbs)
Net
Motor base
Automatic feed-head
Pusher feed-head
Hole feed-heads
Trolley
Disc 1.1

• WORKING HEIGHT

We advise you to place your CL 60 on a stable
surface. There is no recommended working height
as this is a floor-standing model.

• NOISE LEVEL

The equivalent continuous sound level when the CL 60
is operating on no-load is less than 70 dB (A).
W A R N I N G
THE DISCS ARE EXTREMELY SHARP.
HANDLE WITH CARE.
The CL 60 is fitted with magnetic safety system
which stops the motor as soon as the large hopper
or lid is opened, thus preventing any access to the
cutting tool while it is in motion.
As soon as the lid opens, the motor stops.
To restart your machine, simply relock the lid and
press the green switch.
When using the hopper equipped with a lever, the
motor is stopped as soon as the lever is removed
Gross
from the bowl. To start the machine again, you
95 126
should simply position the lever at the aligned with
29 35
the base of the bowl.
15 26
These models are fitted with a thermal safety device
18 24
which automatically stops the motor if the machine
18 22
is left on for too long or is overloaded.
1.3
The hinge pin must be fitted in its position at the back
of the motor unit before the machine is switched on.
Never try to override the locking and safety
systems.
Never insert an object into the container
where the food is being processed.
Never push the ingredients down with your
hand.

SAFETY

Do not overload the appliance.
Never switch the appliance on when it is
empty.
R E M I N D E R
11