Straight And Bias Tubes Feed-Heads; Automatic Feed-Head; Changing The Discs - Robot Coupe CL 60 E Operating Instructions Manual

➋ Slide the hinge pin into
the slots provided at the
back of the motor base.
Next, lock the lid onto
the motor unit using the
locking handle.
- Fill the feeder right up to the top with vegetables.
- Lower the pusher so that it is flush with the top of
the feed opening.
- Press the pusher down to guide the food through
the machine. The exact amount of pressure
required will depend on the nature of the cut,
bearing in mind that too much force reduces
cutting quality without increasing throughput.
- Cut cabbages in half and remove the core before
processing, in order to improve product discharge
and ensure an end-product of a higher quality.
- Lift the pusher and allow access to the feed tube.

• STRAIGHT AND BIAS TUBES FEED-HEADS

❶ Position the 4-tube hopper, or the straight and
inclined tube hopper, on the motor unit. The locking
handle should now be facing you, on the right.
❷ Slip the hinge pin into
the locations provided
at the back of the motor
base. The locking handle
should now be facing you,
on the right.

• AUTOMATIC FEED-HEAD

et Proceed as specified for the pusher feed-
❶ ❷
head.
❸ Screw the agitator
onto the motor shaft.
Screw the agitator onto
the motor shaft.
❹ Position the automatic
hopper on the motor
base. The fastening hook
is now facing you on
your right.
❺ Slide the hinge pin
into the slots provided
at the back of the motor
base.
Then, lock the lid onto
the motor base using the
fastening hook.
➏ Insert the crank into
the central hub of the
head. Turn it until the
part is inside the hub.
The machine should be switched off (by pressing the
red push-button) before starting to change the disc.
With the motor unit facing you, use your right
❶
hand to release the aluminium fastening hook
used to lock the hopper onto the motor base.
a) Feed opening fitted with a lever:
❷
Lift the pusher and release the bowl by tilting
it to the left so that the hopper can be tittled
backwards. Then inscrew the loading cone or
the hollowing cutter. For the hollowing cutter,
use the dismantling tool provided for that
purpose.
b) With tube feed-head:
First remove the inserts and the pushers and
then lift the fastening hook in order to tilt the
hopper backwards to release the bowl.
c) Automatic feeder:
Lift the fastening hook in order to tilb the
hopper backwards to release the bowl.
CHANGING
THE DISCS
9