Introduction; Unpacking Your Turntable; Turntable Contents - Rega P2 Manual

PS2 (UK)
Input 230 V AC 50 Hz 40 mA
Output 24 V AC 100 mA AC
PS2 (EU - Euro 2 pin)
Input 230 V AC 50 Hz 40 mA
Output 24 V AC 100 mA AC
PS2 (Australian)
Input 230 V AC 50 Hz 40 mA
Output 24 V AC 100 mA AC
PS2 (UL - American)
Input 115 V AC 60 Hz 90 mA
Output 24 V AC 100 mA AC
PS2 (Korean)
Input 220 V AC 60 Hz 40 mA
Output 24 V AC 100 mA AC
PS2 (Japan)
Input 100 V AC 50/60 Hz 100 mA
Output 24 V AC 100 mA AC
Warning
Only use the supplied Rega PS2 mains adaptor with
this product.
ENGLISH

Introduction

Please follow this quick set-up guide to ensure optimum
performance and perfect operation. Failure to do so may
invalidate your warranty. For more information on this
product, please visit www.rega.co.uk.

Unpacking your turntable

Always keep the turntable flat.
Follow the packing guide printed inside the front of
the box.
Save the packaging in case you need to transport
your turntable in the future.
Place your turntable on a rigid level surface.
Ensure the drive belt is in place and remove the
transport hub card from beneath the sub platter.
Carefully place the platter on the hub and fit the
turntable mat.

Turntable contents

1. Platter
2. Drive belt / pulley (underneath platter)
3. Tonearm
4. Balance weight
5. Plinth
6. Power input (underside of the turntable)
7. Phono output (rear of the tonearm)
8. On / off switch (underneath plinth)
1