Parking Brake Functions; Emptying The Catcher; Mulching Plug - Simplicity RT Series Operator's Manual

Operating the Tractor
C
Figure 3. Engaging the Parking Brake
A. Ground Speed Pedals
B. Brake Pedal
C. Parking Brake Knob
PARKING BRAKE FUNCTION
Applying the Parking Brake - See Figure 3. To lock
the parking brake, release the ground speed pedals (A),
fully depress the brake pedal (B), pull UP on the parking
brake knob (C), and then release brake pedal.
Releasing the Parking Brake - See Figure 3. To
release the parking brake, fully depress the brake pedal
(B) and push the parking brake knob (C) DOWN.

EMPTYING THE CATCHER

To empty the catcher:
1. Depress the catcher dump pedal (A, Figure 4).
2. Extend the catcher lever (B) and use it to empty the
catcher.
3. Use the lever (B) to close the catcher, and slide it
back into the catcher.
MULCHING PLUG (OPTIONAL)
The mower deck can be converted to a mulching deck by
installing the mulch plug. When mulching always
remember to run the engine at full throttle and reduce
ground speed to allow the deck to cut and re-cut clip-
pings.
Installation
1. Remove the mower deck (see Mower Deck Removal
& Installation).
2. Remove the lower discharge tube (A, Figure 5).
3. Clean out any grass from the underside of the mower
deck. Check the mower blades. Replace if dull or
damaged.
4. Insert the plug into the deck discharge. Secure with
the rubber strap (A, Figure 6).
B
A
Figure 4. Emptying the Hopper
A. Catcher Dump Pedal
B. Catcher Lever
Figure 5. Remove Lower Discharge Tube
A. Lower Discharge Tube
Figure 6. Mulch Plug
A. Rubber Strap
12
B
A
A
A