Installation Of Grass Bag Assembly - Snapper RP216019KWV Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP
engine and blade. Disconnect spark plug wire and
secure away from
components are HOT. Avoid serious burns, allow
sufficient time for all components to cool.
STEP 3: Route recoil rope around outside of rope guide
pulley. See Figure 2.12. (NOTE: Recoil rope may need to
be slackened. Refer to "Starting & Operation".)
FIGURE 2.12
2.9 INSTALLATION OF GRASS BAG
(Door Type Bag)
STEP 1: Install grass bag adapter. Refer to Section
"Installation of Grass Bag Adapter".
STEP 2: Install grass bag by sliding connector over
adapter flange. See Figure 2.13.
STEP 3: Attach grass bag hooks over middle handle
cross bar. See Figure 2.13.
SLIDE
CONNECTOR
OVER FLANGE
FIGURE 2.13
spark plug. Engine
ROUTE RECOIL ROPE
AROUND PULLEY
SECURE
ADAPTER
TO DECK
HOOK TO MIDDLE
HANDLE CROSS BAR
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
and frequently
components immediately.
Grass Catcher bags used on SNAPPER products
are made of woven fabric, and are subject to
deterioration and wear during normal usage.
Check condition
Immediately replace worn or damaged catcher bags
with only bags recommended by SNAPPER. The
grass catcher is optional equipment on some
models.
10
WARNING
and replace worn
WARNING
of bag before
or damaged
each use.