Setup Environment - Vetek DGT Technical Manual

3. SETUP ENVIRONMENT

With "SETUP ENVIRONMENT" we intend a specific menu, inside which it's possible to set all the functioning
parameters of the indicator.
To enter it, turn on the instrument and, while the firmware version is displayed , press the TARE key for an
instant.
The indicator shows the first parameter "tYPE".
NOTE: THE METROLOGICAL PARAMETERS of the SETUP ARE normally NOT ENABLED and therefore are just
displayed.
To enable them, open the instrument and activate the special micro switch (see paragraph 11 "CONNECTIONS
SCHEMES") and then turn it on.
Functions assumed by the keys in the SET-UP ENVIRONMENT:
ZERO
TARE
MODE
PRINT
C-ON/OFF
The display indicates the abbreviation of the step whose meaning is described below. The values indicated
with the (!) symbol at the end of the step, are values set by DEFAULT.
TO EXIT THE SET-UP ENVIRONMENT, PRESS THE C - ON/OFF KEY MANY TIMES UNTIL THE INDICATOR
SHOWS "SAVE? IN THE DISPLAY: CONFIRM WITH PRINT TO SAVE ANY CHANGES MADE OR PRESS
ANOTHER KEY TO NOT SAVE.
Scrolls the programming steps forward in sequence.
If one needs to enter a numeric value, this decreases the digit to be modified (blinking).
Allows to scroll backwards through the programming steps.
In the case in which one enters a numeric value, the selected digit (blinking) increases.
Allows to quickly position on the first step of a menu.
In the case in which one needs to enter a numeric value, select the digit to be modified
(blinking) from left to right.
Allows to enter a step or confirm a parameter inside a step.
Allows to exit a step without confirming the possibly modified parameter and go to the
preceding level.
When entering a numeric value it quickly zeros the displayed value.
9
DGT / DGT60 / DGTQ / DGTP