Error Messages - Vetek DGT Technical Manual

10. ERROR MESSAGES

While using the indicator, it is possible to incur in the following errors:
MESSAGE
It is displayed if one tries to calibrate a point without first having confirmed the number of
PREC.
calibration points
ERMOT Weight unstable during the acquisition of a point during calibration.
ERPNT During the acquisition of a calibration point a null value has been read by the converter.
Error which takes place if the capacity of channel X has not been set, or if there is an error in
Err.X.1:
the calibration parameters of channel X, in which X indicates the number of channel to which
the error refers to.
Er – 11 Calibration error: a too small sample weight has been used; it is advisable to use a weight
equal to at least half of the scale capacity.
Er – 12 Calibration error: the acquired calibration point (tP1 o tP2 o tP3) is equal to the zero point
(tP0).
Scale to be calibrated TECH.MAN.REF. (it is advisable to carry out a technical default,
Er – 37
"dEFAu" parameter, before proceeding).
NOTE: press the
Er – 39 Scale to be calibrated TECH.MAN.REF. (it is advisable to carry out a technical default,
"dEFAu" parameter, before proceeding).
NOTE: press the
During the calibration some internal negative points have been calculated:
C.Er. – 36
the calibration point is less than the zero point.
-
the signal is negative (check the connections)
-
C.Er. – 37 During the calibration some internal points less than the minimum value have been
calculated:
the calibration point is equal to the zero point.
-
A capacity too high in relation to the division has been set.
-
HARDWARE ERROR: software not compatible with the installed hardware; the hardware
hW-Err
expansion component is missing which allows the software to function.
DESCRIPTION
T key before accessing the setup.
T key before accessing the setup.
64
DGT / DGT60 / DGTQ / DGTP