Printing The Heading - Vetek DGT Technical Manual

9. PRINTING THE HEADING

It is possible to programme from the PC the 4 alphanumeric heading lines of 24 characters each, which will be
printed in the manner which has been programmed until these are cancelled or substituted.
One configures the heading by using the DINI TOOLS software on the PC; by following the instructions of the relative
manual, while to select the printing mode of the heading follow the procedure described below:
Enter in the TECHNICAL SET-UP >> SEtup >> SeriAL >> CoM.Prn
CoM.Prn ......
PrConF(§)
......
1. Enter in the step
2. Enter in the step
3. Enter in the step
4. Select the heading printing mode:
int no = does not print the heading
int Si = prints the heading (only with the first totalisation if a totalizer mode has been selected)
= if a totalizer mode is selected, it prints the heading in all the totalisations
int F1
int.SuM = if a totalizer mode is selected, it prints the heading in all the totalisations in the total.
......
IntES
nuMWEi
doM
CoM.Prn
PrConF(§)
IntES
Int no, Int Si, Int Fi, Int.SuM
both, no, tot, SuM
63
DGT / DGT60 / DGTQ / DGTP