Troubleshooting - Snapper P216012E Safety Instructions & Operator's Manual

PROBLEM
Engine Will Not Start 1. Battery is dead.
Using Electric Starter 2. Wiring harness to battery disconnected.
3. Spark plug wire disconnected.
Engine Will Not Start 1. Fuel tank empty.
Using Recoil Starter 2. Engine needs choking or priming.
3. Spark plug wire disconnected.
4. Key switch is not in the "RUN" position.
Engine Stalls or Stops 1. Blade control is released or is not being held
After Running
2. Fuel tank empty.
3. Engine air pre-cleaner and or air cleaner dirty.
4. Spark plug defective or gap set improperly.
5. Water, debris or stale fuel in fuel system.
Engine Loses Power 1. Engine air pre-cleaner or air cleaner dirty
2. Spark plug faulty.
3. Water, debris or stale fuel in fuel system.
Excessive Vibration 1. Damaged, out of balance or bent mower blade.
2. Loose blade components.
3. Loose or missing air lift (if equipped).
4. Lumpy or frayed belt.
5. Bent Idler pulley.
1. Damaged transmission.
Mower Will Not Move
2. Traction drive belt requires replacement.
Loss Of Traction
(Self-Propelled Models) 3. Driven disc slipping.
1. Cutting height too low or high.
Cutting Grass
Improperly 2. Engine speed too slow.
3. Forward ground speed too fast.
4. Terraced cut, side to side.
5. Excessive deck pitch, front to rear.
6. Cutting blade dull or damaged.
Poor Grass Discharge 1. Engine speed too slow.
2. Forward speed too fast.
3. Grass is wet.
4. Excessively worn or damaged blade.
5. Build up of grass clippings and debris under deck.
6. Improper blade installed on deck.
7. Blade installed improperly on deck.
1. Leaking engine case.
Oil Leaking

TROUBLESHOOTING

PROBABLE CAUSE
securely against handle.
1. Charge or replace battery.
2. Connect wiring harness and tighten securely.
3. Place spark plug wire onto spark plug.
1. Fill fuel tank with fresh fuel.
2. Choke/Prime engine. Check Engine Manual for
instructions.
3. Place spark plug wire onto spark plug.
4. Turn key switch to the "RUN" position.
1. Blade control should be held securely against
handle at all times during operation of mower.
2. Fill with fuel to proper level.
3. Clean free of all debris.
4. Service spark plug.
5. Drain and clean fuel system.
1. Clean or replace filters.
2. Service spark plug.
3. Drain and clean fuel system.
1. Service mower blade.
2. Service and tighten loose parts.
3. Replace air lifts. Tighten to proper torque.
4. Replace belt.
5. Replace pulley.
1. Contact authorized SNAPPER dealer.
2. Replace traction drive belt.
3. Clean or replace driven disc.
1. Adjust cutting height.
2. Move engine speed control to "FAST" position.
3. Move ground speed control to a slower speed.
4. Adjust height of cut with height adjust levers.
5. Adjust height of cut with height adjust levers.
6. Sharpen cutting edges or replace blade.
1. Move engine speed control to "FAST" position.
2. Move ground speed control to a slower speed.
3. Mow when grass is dry.
4. Service mower blade.
5. Clean deck.
6. Install proper SNAPPER blade.
7. Install blade properly.
1. Contact authorized SNAPPER dealer.
2. Check and tighten drain plug.
3. Make sure dip stick or oil filler cap is securely in
place.
21
CORRECTIVE ACTION