Safety Warnings; Registration Procedure - Marmitek PROGUARD 800 series User Manual

SAFETY WARNINGS

• Do not expose the components of your systems to extremely high temperatures
or bright light sources.
• In case of improper usage or if you have altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case
of improper usage of the product or when the product is used for purposes other
than specified. Marmitek does not accept responsibility for additional damage other
than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• The product should only be repaired or serviced by a qualified repairman.
• Keep batteries out of the reach of children. Dispose of batteries as chemical
waste. Never use old and new batteries or different types of batteries together.
Remove the batteries when you are not using the system for a longer period of
time. Check the polarity (+/-) of the batteries when inserting them in the product.
Wrong positioning can cause an explosion.
• Automatic switching devices provide comfort, but can also be dangerous. They
can surprise people or can ignite clothing hanging over an electric heat source.
Please be careful and take appropriate measures to avoid accidents.
INTRODUCTION
The PR811 and KR814 are keyfob transmitters. This product is a part of the Marmitek
ProGuard800 series, and operates together with the ProGuard800 alarm system.
When you wish to know more about the complete system, its possibilities and its
settings, then you
www.marmitek.com.

REGISTRATION PROCEDURE

To register keyfobs:
1. From the Programming menu, select Devices, Keyfobs [912].
2. Select the keyfob you want to register; the system initiates Registration
mode.
3. Press a button, making sure that the keyfob's LED lights up when the
button is pressed.
4. Press the same button again. When Save? appears on the panel's LCD
display, press 9.
PR811
The PR811 is a one-button transmitter that generates a
Medical Emergency alarm when pressed. The transmitter is
water resistant and can be worn around the neck. Its large
button makes it ideal for elderly or sight-impaired users.
When the battery is low, the PR811's LED flashes during
transmission and a Low Battery signal is sent to the receiver. When
either of these two indications are observed, replace the
battery.(CR2032)
PR811 & KR814
can check out the installation manual or visit
2