Installation Instructions; Module Installation - Vision TECHCONNECT TILT Owner's Manual

INSTALLATIoN INSTRUCTIoNS

Take the following steps to install this product:
1. Decide on placement. This is normally in the exact centre of the table to allow easy
access for all users.
2. Cut a hole in the table. The diameter can be from 220-226mm. for best results use a
220mm hole-saw which fits to a standard power drill with an Arbor. Alternately, if you
use a jigsaw or handsaw attach the cardboard template to the table surface and use as
a cutting guide. When cutting into the table surface beware of power cables beneath.
The Techconnect Tilt mounting system can accommodate any table thickness up to
110mm thick.
3. Remove the mounting clamp m5 Wingnuts (4) from the Techconnect Tilt, and carefully
lower it into the hole from the above.
4. Hold the mounting clamp in place against the underside of the table, and attach the 2
x m5 Wingnuts (4) tightly. Repeat for the clamp on the other side. Then tighten the m6
Wingnut (5) to firmly clamp the Techconnect Tilt to the table.
5. Connect power and touch the "UP/DoWN" button on the top surface to power the
faceplate into the UP position.

moDULE INSTALLATIoN

1. Techconnect modules
2. Techconnect Surround
3. m3 countersunk screws
6
1. Table
2. Techconnect Tilt
3. mounting Clamps
4. 2 x m5 Wingnuts
5. m6 Wingnut