Table of Contents
Advertisement
≥The Status indicator goes off when the power
turns off.
How to turn the power on and off with the LCD
monitor/viewfinder
When the power switch is set to [ON], the power
can be turned on and off with the LCD monitor
and the viewfinder when the unit is in Tape
Recording Mode or Card Recording Mode.
1
Open the LCD monitor out or extend the
viewfinder to use.
≥The LCD monitor or viewfinder will be
activated.
2
Close the LCD monitor and retract the
viewfinder.
≥The power will not turn off unless the LCD
monitor is closed and the viewfinder is
retracted.
≥The power does not turn off even if the
LCD monitor is closed and the viewfinder
is retracted while recording on a tape.
3
Open the LCD monitor or extend the
viewfinder to turn the power on and use the
movie camera again.
≥The Status indicator lights red and the power
turns on.
ª
Inserting/removing a cassette
1
Fit the AC adaptor or the battery and turn on
the power.
2
Slide the [OPEN/EJECT] lever and open the
cassette cover.
≥When the cover is fully opened, the cassette
holder will come out.
3
After the cassette holder is opened, insert/
remove the cassette.
≥When inserting a cassette, orient it as shown
in the figure, and then securely insert it as far
as it goes.
≥When removing, pull it straight out.
4
Push the [PUSH] mark 1 in order to close
the cassette holder.
≥The cassette holder is housed.
5
Only after the cassette holder is completely
housed, close the cassette cover tightly.
OPEN/
EJECT
1
PUSH
63
VQT0T48
Advertisement
Table of Contents
