Panasonic WJ-ND300 Maintenance Manual page 14

WJ-ND300 SATA conversion guide (single)
(36) Install new HDDs on the HDD mounting brackets with four screws each. Refer to the "Operating Instructions" for detail.
Notes:
When disconnecting the ATA cables, pull the pull-ring slowly and straightforward.
SATA HDD's do not require jumper configuration.
Install the HDD, board side facing down and the connectors pointing toward the front.
Take care not to deform the dampers when installing the HDD.
(37) Install the HDD unit in the reverse order of the removal.
(38) Connect the SATA cables to the HDDs as shown right.
Make sure that the connectors have been inserted com-
pletely.
(39) Attach the SATA Cable label to the specified location on
the front panel chassis.
(40) Remove HDD Caution label from the Front panel Ass'y,
and attach new HDD Caution label.
Panasonic
SATA cable
for HDD2
(gray)
SATA cable
for HDD1
(red)
SATA Cable label
HDD Caution label
14
ND300_SATAConversionGuideS_A
Maintenance guide
SATA cable
for HDD4
(gray)
SATA cable
for HDD3
(red)