Panasonic WJ-ND300 Maintenance Manual page 8

WJ-ND300 SATA conversion guide (single)
(17) Install three additional hexagonal spacers (7mm).
(18) Attach the new cool sheet to the Main board (Center of
IC103).
(19) Meeting the hexagonal spacers, install the SATA board
mounting bracket with four screws (1x wafer-head screw,
3x screw with washer).
(20) Install the SATA board with additional four screws.
Note: Circled tapped holes on the SATA connector side are not
necessarily screwed.
(21) Remove two cord clamps from the HDD Fan Ass'y, and attach four new cord clamps.
Note: Peel off the double-sided tape, not leaving any portion.
HDD Fan Ass'y
Panasonic
Attach four new cord clamps
Remove
two cord clamps
screw with washer
SATA board
mounting bracket
additional
Hexagonal spacer
three screws (7mm)
20mm
unites with a
10mm
left end.
8
ND300_SATAConversionGuideS_A
Maintenance guide
additional four screws
(screw with washer)
SATA boards
New
cool sheet
Main board
wafer-head
IC103
screw
10mm