HP MCS G2 Installation Overview page 6

b. In the password field, enter the password. The default
password is Admin. The Main Menu screen appears.
7. Enter the product ID and serial number. The product ID and 10-
digit serial number are located on a label inside the rear MCS
unit door.
a. From the Main Menu screen, enter 3 Factory Default.
The Default Product Identification screen appears.
b. To set the product ID, enter 2 Product ID MCS.
c. To set the serial number, enter 3 Serial Number MCS.
d. To return to the Main Menu screen, press Esc.
8. Access the HP Modular Cooling System Configuration Utility.
a. From the Main Menu screen, enter 1 Network
Configuration. The Menu Network Configuration
screen appears.
b. Enter 1 IP Configuration. The IP Configuration screen
appears.
c. To disable DHCP, enter 4 Enable/Disable DHCP.
d. Enter 1 IP Address, and then enter the new IP address.
e. Enter 2 IP Subnet mask, and then enter the IP subnet
mask.
f. Enter 3 IP Def. Router, and then enter the gateway.
9. Activate the values.
a. Return to the Main Menu Network Configuration screen.