Table of Contents
Advertisement
11. Cap the unused side of each T-fitting on the MCS unit using the
cap wrench.
12. Route the two drain hoses to the drain collection system catch
basin.
a. Install and route the blue drain hose into either the
condensation return line or the gravity drain collection
system catch basin.
b. Route the preinstalled clear drain hose into the gravity
drain collection system catch basin.
c. Position the gravity drain collection system below the
condensation collection pan, allowing gravity to draw the
water out of the condensation collection pan and into the
gravity drain collection system basin.
13. Turn on the water by opening the four ball valves.
a. Open the ball valves at the facility water line connections.
b. Open the ball valves at the main hose connections.
14. Plug the network cable into the RJ-45 connector on the power
inlet box.
15. Plug the other end of the network cable to your network
connection.
IMPORTANT: Do not connect the power cords into a
power supply.
16. Plug the primary power cord into the power connector on the
left.
WARNING: To reduce the risk of electric shock or
damage to the equipment:
Do not disable the power cord grounding plug. The
•
grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed)
•
electrical outlet that is easily accessible at all times.
•
Unplug the power cord from the power supply to
disconnect power to the equipment.
•
Do not route the power cord where it can be walked
on or pinched by items placed against it. Pay
particular attention to the plug, electrical outlet, and
the point where the cord extends from the storage
system.
Advertisement
Table of Contents
