H3C S3610 Series Operation Manual page 10

Operation Manual – System Maintaining and Debugging
H3C S3610&S5510 Series Ethernet Switches
acquire a higher privilege, you must switch to a higher user level, and it requires
password to do so for AUX and VTY user interfaces for the security's sake.
The following table describes the default level of the commands.
Table 1-3 Default command levels
Level
0
1
2
3
Follow these steps to configure user level and command level:
Switch the user level
Enter system view
Configure the password
for switching the user
level
Configure the command
level in system view
Note:
The commands available depend on your user level when you log onto a device. For
example, if your user level is 3 and the command level of VTY 0 interface is 1, you can
use commands below level 3 (inclusive).
Privilege
Visit
Monitor
System
Manage
To do...
super [ level ]
system-view
super password [ level
user-level ] { simple |
cipher } password
command-privilege
level level view view
command
ping, tracert, telnet
refresh, reset, send
All configuration commands except for those at
manage level
FTP, TFTP, XMODEM, and file system
operation commands
Use the command...
1-9
Chapter 1 Basic Configurations
Command
Remarks
Optional
Available in user view.
—
Optional
By default, no password is
configured.
Optional