Installing The Grass Catcher - Snapper ELP21703BDV Safety Instructions & Operator's Manual

Operation (Continued)
WARNING
!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT. Avoid serious
burns, allow sufficient time for all components to cool.

Installing the Grass Catcher

1. Follow the WARNING statement found on this page.
2. Lift the discharge door (A, Figure 8) located at the rear
of the machine.
3. Install the grass catcher (B) onto the rear of the
machine. Position the rod ends (C) of the catcher frame
over the tabs (D) located at the rear of deck. Release the
discharge door, which is spring loaded, onto the top of
the grass catcher.
A
C
B
Figure 8: Installing the Grass Catcher
10
!
!
DO NOT operate mower without entire grass catcher, side
chute or recycling plug in place. Grass Catcher
components are subject to deterioration during normal
use. Inspect frequently and replace worn or damaged
components immediately.
!
Grass Catcher bags used on SNAPPER products are made
of woven fabric, and are subject to deterioration and wear
during normal usage. Check condition of bag before each
use. Immediately replace worn or damaged catcher bags
with only bags recommended by SNAPPER. The grass
catcher is optional equipment on some models.
D
WARNING
WARNING
www.snapper.com
!
!