Table of Contents
Advertisement
Maintenance (Continued)
WARNING
!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT. Avoid serious
burns, allow sufficient time for all components to cool.
Wear heavy leather gloves when handling or working
around cutting blades. Blades are extremely sharp and can
cause severe injury.
Mower Blade Replacement
Standard Blade Wear Limit
1. Inspect the blade (Figure 11) frequently for signs of
excessive wear or damage:
(A) New blade
(B) Wear limit (notch starts)
(C) Dangerous condition! Do not use on the mower!
Replace with a new blade.
Figure 11: Standard blade wear limits
!
Blade Sharpening
Important: Drain the fuel tank before tipping the mower. DO
NOT tip the machine with the carburetor or spark plug down.
Oil from the crankcase will saturate the air filter and cause
the engine to be hard to start or not start at all. If
contamination does occur, the air filter will have to be
replaced.
A
B
C
WARNING
!
DO NOT use a cutting blade that shows signs of excessive
wear or damage. Refer to the Section entitled "MOWER
BLADE REPLACEMENT" for proper blade inspection and
service procedures.
1. Disconnect the spark plug wire and secure the end away
from the plug.
2. Tilt the mower up on its rear wheels. Do not tilt the
mower with the spark plug or carburetor down.
3. Remove the blade (B, Figure 12).
D
Figure 12: Removing the mower blade
!
A
B
C
13
Advertisement
Table of Contents
