Advertisement
ELECTRICAL REQUIREMENTS
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is
recommended that a separate circuit breaker serving only this appliance be provided.
Location Requirements (cont.)
Closet installation (washer only):
(457 mm)
(864 mm)
*
4"
(102 mm)
*
1"
(25 mm)
Drain System
Drain system can be installed using a floor drain, wall standpipe, floor
standpipe, or laundry tub. Select method you need.
IMPORTANT: To avoid siphoning, only 4
should be inside standpipe. Always secure drain hose with cable tie.
Floor standpipe drain system
4
4.5"
/
"
1
2
(114 mm)
(114 mm)
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum carry-
away capacity: 17 gal. (64 L) per minute. A 1/4" (6 mm)
diameter to 1" (25 mm) diameter Standpipe Adapter Kit is
available (Part Number 3363920). Top of standpipe must be at
least 24" (60 cm) high; install no higher than 49" (125 cm) from bottom of
washer. If you have an overhead sewer and need to pump higher than 96
inches, a sump pump and associated
hardware are needed. See "Alternate Parts."
Wall standpipe drain system
4
/
"
1
2
(114 mm)
See requirements for floor standpipe drain system.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
3"
18"
(76 mm)
34"
48 in.
(310 cm
24 in.
(155 cm
3"
(76 mm)
*
1"
(25 mm)
* Recommended
spacing. Minimum
0" (0 mm)
⁄
" (114 mm) of drain hose
1
2
max. 48"
max. 49"
(1219 mm)
(125 cm)
min. 30"
min. 24"
(762 mm)
(60 cm)
max. 49"
max. 49"
(1250 mm)
(125 cm)
min. 24"
min. 24"
(60 mm)
(60 cm)
Laundry tub drain system
4
4
/
/
"
"
1
1
2
2
(114 mm)
(114 mm)
min.
2
)
2
Minimum capacity: 20 gal. (76 L). Top of laundry tub must
be at least 24" (60 cm) above floor; install no higher than
49" (125 cm) from bottom of washer.
min.
2
)
Floor drain system
2
Floor drain system requires a Siphon Break Kit (Part Number 285834), 2
Connector Kits (Part Number 285835), and an
Extension Drain Hose (Part Number 285863) that may be
purchased separately. See "Alternate Parts." Minimum siphon break
height: 28" (710 mm) from bottom of washer. (Additional hoses may be
needed.)
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
max. 49"
max. 49"
max. 49"
(1250 mm)
(1250 mm)
(125 cm)
min. 24"
min. 24"
min. 24"
(60 mm)
(60 mm)
(60 cm)
Advertisement
