Tantalus XR-3100 Installation Manual page 18

L A N N E T W O R K S T A T U S L E D ( R E D )
Start-up/Power up
Module is not programmed
Unassociated/Re-associating
Valid association candidate found
Full network association confirmed
L A N A P P L I C A T I O N M E S S A G E T R A N S A C T I O N L E D ( G R E E N )
Start-up/Power-up
Message queued for transmission
Valid message received (addressed to this device)
L A N R F P A C K E T L E D ( A M B E R )
Start-up/Power-up
RF packet transmitted
RF packet received (LAN activity)
Check the WAN LED on the mid cover to ensure full two-way communication with the NC-2200.
If
The XR-3100 does not power up.
The XR-3100 powers up but does not
appear to find a Tantalus channel.
The XR-3100 finds the Tantalus
channel but does not appear to be
addressed by the controller.
If you still can't get a signal and you are only using the internal antenna, try installing an external
antenna to the device to boost the signal strength.
page 12
Then
Remove the unit and replace it with another one.
Remove the unit and replace it with another one.
When back in the Meter shop, ensure that the
Tantalus channel has been programmed in the scan
list.
Contact the NC-2200 Administrator to verify that the
unit is being installed and the WAN Network ID has
been registered in the database. If it has not been
registered, ask that it be registered now.
Solid RED
Fast flashing RED
Solid RED
Flashing RED
OFF
OFF
Long flash GRN
Short flash GRN
OFF
Long flash Amber
Short flash Amber
Tantalus Systems Corp.