Tantalus XR-3100 Installation Manual page 10

Figure 1 The XR-3100 serial port with the DT-
100 Cross band programming cable attached.
Figure 3 Switch position to select the
LAN Controller.
5. Plug in the power cord. The CONFIG LED should now be green as shown in Figure 4. If it
is red, immediately disconnect the power cord and check the toggle switch on the
programming connector.
6. Start the DT-150 software. Click the read icon
Should nothing come up then check all connections and settings.
7. LAN Programming:
page 4
PROGRAMMING
CONFIGURATION
LED
WAN
STATUS
LED
Figure 2 Position of the XR-3100 programming and status LEDs
Figure 4 The green programming CONFIG LED
indicating communication to the LAN Controller.
LAN
STATUS
LEDs (3)
once. A new window will appear.
Tantalus Systems Corp.