Tantalus XR-3100 Installation Manual page 16

4. Install the battery in the XR-3100. Depress the battery cover tab, lift the cover, and install
the batteries (orientation not critical) with the exposed contacts inward.
!
Caution
5. Attach power to the XR-3100:
a. Connect the white power/neutral wire, black power wire, and green chassis ground wire to
the terminal block per the markings on the inner cover.
b. Ensure that there are several inches of strain relief available in the wires. Secure a tie
wrap to the slots in the inner cover.
6. Turn on the power.
7. Observe the LEDs on the left side of the XR-3100 to verify that two-way communication is
established.
•
For a description of the LEDs, turn to Troubleshooting the XR-3100 on page 11.
8. Attach the top cover by sliding the faceplate down over the device. The cover will snap
into place if correctly installed.
9. Engage the barrel lock.
page 10
Ensure that you are using a Tantalus-approved battery only.
Do NOT apply power to the XR-3100 until the battery has been installed.
A green WAN LED indicates that the XR-3100 is operational.
Tantalus Systems Corp.