Section 3 - Maintenance Instructions; Change Engine Oil; Check Transmission Grease - Snapper CRP216019KWV Safety Instructions & Operator's Manual

Section 3 – MAINTENANCE
3.1 INTRODUCTION
To retain the quality of the mower, use genuine
SNAPPER replacement parts only. Contact a local
SNAPPER dealer for parts and service assistance.
For the correct part or information for a particular
mower, always mention model and serial number.
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
3.2 SERVICE - AFTER FIRST 5 HOURS

3.2.1. CHANGE ENGINE OIL

1. Refer to Engine
specifications, procedures
intervals.
2. On Kawasaki engines, the oil drain plug is located
in a spot that will prove both inconvenient and messy
for draining oil. For simplest/cleanest oil change,
simply tip mower on its side. See Figure 3.1. Drain oil
through dipstick tube into a container. Allow sufficient
time for all oil to drain.
IMPORTANT: Drain fuel tank before tipping machine.
DO NOT tip machine with carburetor or spark plug down.
Oil from crankcase will saturate the air filter and cause the
engine to be hard to start or not start at all. If
contamination does occur, the air filter will have to be
replaced.
FIGURE 3.1
3. Dispose of drain oil properly.
4. Fill engine with oil as specified in Engine Manual.
Do Not overfill.
Manual for proper
and proper service
REMOVE OIL CAP
TIP MOWER TOWARD
RIGHT REAR
NOTE: Check specific model engine owner's
manual for changing engine oil procedure and oil
specifications.
3.2.2. CHECK GREASE LEVEL IN TRANSMISSION
1. Remove transmission fill plug. Roll machine
forward or backward while looking down into plug
hole.
2. If liquid grease IS NOT visible on the input gear
(the small gear below the plug hole), add an
amount, to cover gear, of Snapper "00" grease. See
Figure 3.2.
FILL PLUG
oil
NOTE: Snapper "00" Grease (Part No. 7029443) is
available at your SNAPPER dealer.
NOTE: Do not spill grease or oil on surface of drive disc.
See Figure 3.4.
3. Reinstall transmission plug.
4. Check grease level after each 25 hours of
operation.
12
FIGURE 3.2
KEEP DRIVE DISC CLEAN !
FIGURE 3.4