Subscribe to Our Youtube Channel
Related Manuals for e-Joe Epik SE
Summary of Contents for e-Joe Epik SE
- Page 1 EPIK SE USER MANUAL 48V 500W EDITION Please, read before operating your new bicycle...
- Page 2 Even a small amount of alcohol will limit your ability to be safe on the road. e-JOE cares for the environment and encourages its customers to properly dispose of e-JOE products in accordance with local regulations. When you need to dispose of a lithium-ion battery, please, either dispose of the unwanted battery through an approved recycler or send it back to us and we will make sure it is properly recycled.
-
Page 3: Opening Your Bicycle
● Battery keys (2) After unpacking, please, do not discard the box and protective material until you test the bike and make certain it is in good working condition. Contact your dealer or e-JOE Bicycle if any of these parts are missing. - Page 4 STRUCTURE OF YOUR E-BIKE Currently, electric bicycles can be divided into two classes: TAG (Twist-and-go) and PAS (Pedal Assist System). EPIK SE belongs in the second classification. Refer to the picture below for structure and parts.
-
Page 5: Main Specifications
MAIN SPECIFICATIONS BIKE Weight (with battery) 50 lbs. Max Capacity 300 lbs. Dimension 65” x 27” x 46” Max Speed 20 mph Full Charge Distance up to 30 miles (depending on terrain and rider’s weight) Climbing Grade ≤ 10% Pedal Assist System Thumb Throttle Control &... - Page 6 ASSEMBLY EPIK SE folding electric bicycle is shipped 98% assembled. In order to fully assemble the bike and prepare it for the first use, follow these simple steps: Step 1: Packing Material Remove all packing and protective material and put aside. Do not discard the box or any shipping material until you test the bike and make certain it is in good working order.
- Page 7 BRAKES EPIK SE has a disk brake system installed on both the rear and the front and is used to control the entire braking system of the bicycle. Brake Precautions ● Do not brake too strongly or abruptly, as it will make it easier for you to fall down.
-
Page 8: Seat And Handlebar Safe Height Mark
SEAT AND HANDLEBAR SAFE HEIGHT MARK Vertical Handle Stem Position Appropriate adjustments can be made for the vertical handle stem according to personal preference or riding habit, but it is forbidden to expose the infix notation (also called, the safety line). If used inappropriately, it may cause serious injury to the rider. - Page 9 Battery ON/OFF Switch Each EPIK SE battery is equipped with a red ON/OFF switch to preserve the battery when not in use. When the battery is locked into the frame this switch is accessible through the port on the left side of the frame under the black rubber cap.
- Page 10 To see the battery charge level, use the charge indicator on the Electric Assist LCD Display located on the left handlebar. The battery charger for the EPIK SE is equipped with an LED light indicator that works to help you preserve the battery life of your bicycle by allowing you to see if your EPIK SE is completely charged.
-
Page 11: Lcd Display
LCD DISPLAY EPIK SE is equipped with the multifunctional LCD power assist display. Depending on the year of production, two types of displays are used on the bikes: 1) The display No. 1 has two main buttons (ON/OFF/UP (1), SET/DOWN (2)), a monitor (3), and a thumb throttle (4). - Page 12 Wheel diameter selection Hold the UP button for 10 seconds and enter the wheel diameter selection interface. The standard setting for EPIK SE in 20 inches (1590 mm). Error code definition When the electric control system of the bike is out of order, the display will automatically display the error code and stop working properly.
- Page 13 2) The display No. 2 has three main buttons: M (MODE), + (UP), - (DOWN), a monitor, and a thumb throttle. ON/OFF Hold MODE for a couple of seconds to turn on the display and supply power to the controller. To turn off the display, press and hold MODE to shut off the power.
- Page 14 How can I handle the error code of the display? DO NOT attempt to open and/or repair the bike components. Doing so will void the warranty and can result in a safety hazard. Visit your local e-JOE Bike Dealer, or call our technical support +1-855-888-1891.
-
Page 15: General Operating Instructions
GENERAL OPERATING INSTRUCTIONS Before You Ride for the First Time: ● Check that lever for the handlebar stem is properly tightened. ● Check that locking lever for folding pipe is tightened and the safety clip ring is in place. ● Check that the folding lever for the frame is tightened and safety clip is in place. If the folding lever is too tight and makes it difficult to lock the frame, try loosening the locking bolt: use 6mm allen wrench and turn the locking bolt half or three-quarters in the clockwise direction to loosen it. -
Page 16: Folding Instructions
FOLDING INSTRUCTIONS EPIK SE can be folded for easy storage and travel. Pedals: Depending on the type, fold the pedals by: pressing the end of the pedal inward and then upwards; pressing the inner locking mechanism and folding the pedal Folding Pipe: Locate the locking lever at the base of the folding pipe. -
Page 17: Maintenance
FOLDING INSTRUCTIONS Frame: Locate the frame locking lever on the right side of the frame. Unlock the frame by 1st moving the black safety clip upwards, and then pulling the silver locking lever out and towards the rear of the bicycle. MAINTENANCE Like any other mean of transportation, electric bicycle and its components are subject to wear and tear. -
Page 18: Warranty
7 days after delivery. It is the customer’s responsibility to inspect the box and the product at the time of delivery, take pictures of any damage and keep all... - Page 19 Replacement products may be new or reconditioned. All products that are replaced will become the property of e-JOE and must be returned upon request. Any item repaired or replaced under these terms will be covered by the limited warranty for the remainder of the original warranty period.
-
Page 20: Simple Troubleshooting
SIMPLE TROUBLESHOOTING PROBLEM SOLUTIONS A. Top speed too slow 1. Fully recharge battery B. Power on but motor not working 1. Reinstall battery/ Replace fuse C. Driving shorter distance per recharge 1. Check tire pressures 2. Recharge completely or have charger re-inspected 3. - Page 21 CONTACT US We hope you enjoy your new e-JOE bike! If you have any questions/comments/concerns or would like to share your e-JOE bike experience, please contact us at: Telephone: 855-888-1891 Email: sales@ejoebike.com Website: www.ejoebike.net Follow us on Facebook and Instagram! www.facebook.com/ejoebike...
Need help?
Do you have a question about the Epik SE and is the answer not in the manual?
Questions and answers