Section 3 - Maintenance Instructions; Change Engine Oil - Snapper CP215017KWV, CP216017RV, CP214017R2 Safety Instructions & Operator's Manual

21” steel deck walk mowers commercial model series 17
Hide thumbs Also See for CP215017KWV, CP216017RV, CP214017R2:
Table of Contents

Advertisement

Section 3 - MAINTENANCE
3.1 INTRODUCTION
To retain the quality of the mower, use genuine
SNAPPER replacement parts only. Contact a local
SNAPPER dealer for parts and service assistance.
For the correct part or information for a particular
mower, always mention model and serial number.
3.2 SERVICE - AFTER FIRST 5 HOURS

3.2.1. CHANGE ENGINE OIL

WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP
engine and blade. Disconnect spark plug wire and
secure
away
from
components are HOT. Avoid serious burns, allow
sufficient time for all components to cool. Wear
heavy leather gloves when handling or working
around cutting blades. Blades are extremely sharp
and can cause severe injury.
1. Refer
to
Engine
specifications, procedures and proper service
intervals.
2. For simplest/cleanest oil change, loosen lower
handle nuts. Remove two of the four bolts and fold
handles. Stand mower up on lower handle
brackets as shown in Figure 3.1A. Drain oil
through dipstick tube into a container. Allow
sufficient time for all oil to drain.
FIGURE 3.1A
spark
plug.
Engine
Manual
for
proper
IMPORTANT: Drain fuel tank before tipping machine.
DO NOT tip machine with carburetor or spark plug down.
Oil from crankcase will saturate the air filter and cause
the engine to be hard to start or not start at all. If
contamination does occur, the air filter will have to be
replaced.
3. Alternate Oil Drain: Procedure: The Kawasaki
and Robin 4-Cycle engines are equipped with oil
drain plugs located above the deck on the left side
of the engine. See Figure 3.1.B and Figure 3.1.C.
Remove oil drain plug to drain oil. Allow sufficient
time for all oil to drain. Reinstall plug and tighten
securely.
4. Dispose of drain oil properly.
5. Fill engine with oil as specified in Engine
and
Manual. Do Not overfill.
6. Robin 4-Cycle engines are equipped with an oil
filter. Refer to Engine Manual for correct replacement
intervals.
NOTE: Check specific model engine owner's
manual for changing engine oil procedure and oil
oil
specifications.
OIL DRAIN
PLUG
OIL DRAIN
PLUG
9
ROBIN ENGINE
OIL
FIGURE 3.1B
KAWASAKI ENGINE
FIGURE 3.1C

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp215017kw

Table of Contents