Advertisement
Programming the Z-Wave Light Kit
Programming the Z-Wave Light Kit to the i-Drive TorqueMaster
Pro.
If your Z-Wave Light Kit is included with the opener, it should
already be programmed to the opener. Otherwise, follow the
instructions below.
IMPORTANT: ERASE ANY EXISTING PROGRAMMING ON
Z-WAVE LIGHT KIT
1.
Press and hold the DELETE button on the unplugged
Wireless Gateway until the 3 LEDs turn on, then let go of the
button.
2.
Press the red button on the Z-Wave Light Kit and
observe the LEDs on the Wireless Gateway flash. All network
programming, if any, has now been deleted from the Z-Wave
Light Kit. Press the red button again to turn off the light. If the
button is held in, the Z-Wave Light Kit may flash its light on
and off repeatedly. This is okay.
PROGRAM Z-WAVE LIGHT KIT TO PRIMARY CONTROLLER
1.
Insure the Z-Wave Light Kit light is off.
2.
Press the Scene 1 button on the Wireless Gateway and
observe that the LED lights up. Continue holding the button
down until the LED turns off and the turns back on again.
3.
While the Scene 1 button is still being pressed, press
the red button on the Z-Wave Light Kit, while observing the
LED for Scene 1. If the LED flashes, the Z-Wave Light Kit has
been successfully programmed to Scene 1 of the Wireless
Gateway.
4.
Release the button on the Wireless Gateway.
5.
Note: If the programming was unsuccessful, try moving
the Wireless Gateway closer to the Z-Wave Light Kit or change
orientation.
COPY PRIMARY CONTROLLER PROGRAM TO THE Z-WAVE
OPERATOR
1.
Press and hold the Learn button on the I-Drive
TorqueMaster
®
Pro until all 4 LEDs are blinking. Release the
button.
2.
With the Wireless Gateway in close proximity to the
I-Drive TorqueMaster
®
Pro, press and hold the copy button on
the Wireless Gateway until all 3 LEDs are flashing.
3.
Observe the 4 LEDs on the I-Drive TorqueMaster
programming is successful, the LEDs will begin blinking at a
different rate, and then turn off. If not, then you may have to
move the Wireless Gateway closer or change the orientation.
4.
The Z-Wave Light Kit will now come on when the
operator is engaged. The light will automatically shut off after
approximately 5 minutes. Additionally, by default, Scene 3 will
turn off Scene 1. Therefore, the light can be turned off by
pressing Scene 3 on the Wireless Gateway.
(3) Mating Slots
Light Bulb
(Not Included)
Caution!
Risk of Fire
Use Only 19W Max.
COMPACT
FLUORESCENT
Caution!
Risk of Fire
Use Only 15W Max.
TYPE- A
Program Button
®
Pro. If
Pg 2
Power Socket
Light Fixture
Light Socket
Snap Tabs
Diffuser
LED
Light Button
Wireless Gateway
Advertisement
