Conventions And Diagrams - QED MicroPurge basics MP10UH Instruction Manual

Diagrams and Conventions used in the Text
MP10UH Panel Layout:
Battery Cover
O
MODEL
U
asics
CONTROLLER
ED
MicroPurge Mode Quick Guide
1. Opening cover turns power ON. (Close to turn OFF.)
2. Select desired Cycles Per Minute (CPM) with the
(default value is 4 CPM).
3. Turn throttle to set depth on gauge to 10-20 feet
deeper than the pump location in the well.
4. Press CYCLE to START pumping.
5. When water discharge begins, adjust throttle until
a slow, steady flowstream is achieved.
6. Press keys to set the desired purge flow.
7. Use II key to directly control sample flow and pause.
3 AA BATTERIES INSIDE
MicroPurge Basics Controller
MP Micro Purge MN Manual Time Set
ID ID Time Set LVL LevelShutoff
Time
00.1 1 03 1 0.0
M PC P M 4 >05.0
Mode CPM
CPM/Value Flow/Value
CYCLE MODE
ID/MN/MP/
Start/Stop
Battery
MP10UH Control
Keypad and display
Connector for optional
MP30 Drawdown Control
MP10UH
key
CONTROL PORT
1-800-624-2026
micropurge.com
ID R efill
Discharge
Flow/Value
I I
Hold/Sample E D
0
/Cycle
Pressure Gauge
AIR IN
E D
AIR OUT
DISCHARGE CYCLE
ps i
T HR OT T L E
2
Compressed gas source
connection
Controller to pump
connection
Discharge cycle
indicator
Flow throttle