•
Then press the PROG/ MEMORY button (6) on the unit.
•
Press M-UP or M-DN Buttons on the unit (19,17) or on the remote control (10,11) to select
the desired channel memory and press the PROG/ MEMORY button button within 5
seconds to store it.
To reprogram a preset station repeat the procedure above.
Selecting a preset station
To select a preset station, press the M-UP or M-DN Buttons on the unit (19,17) or on the remote
control (10,11) until the desired preset program is displayed.
FM Stereo Reception
When an FM signal is tuned in, the ((( ST. ))) indicator will appear in the display.
In case of noisy reception, if you push the INTRO/MONO-STEREO button (22) to FM MONO
position, the FM STEREO indicator will turn off & switch to MONO FM status.
Antenna
For FM reception there is a wire antenna (33) at the rear of the unit. Extend it for best reception.
For MW reception the signals are picked up through an external Loop antenna (34). Your
may have to orient the antenna to obtain the best reception.
CASSETTE OPERATION
INSERTIONAND REMOVALOF CASSETTES
•
Open the cassette keys cover (30).
/
•
Press the Stop/Eject (
) Button (27) to open the Cassette Door. .
•
Slip your cassette tape into the holder, with the exposed section downward and the
playback side facing you.
•
Close the Cassette Door (2) securely before starting.
•
When finished, press the Stop/Eject Button to open the Cassette Door, and retrieve your
cassette tape.
PLAYBACK
•
Press the Function Button (20) to select TAPE function.
•
Insert your cassette tape.
•
Press the Play button ( ) to active playback.
•
Use the Pause button (II) whenever you want to suspend playback.
•
Press the Stop/Eject button to stop playback.
English
7
TO RECORD ON A CASSETTE
•
•
RECORDING FROM THE RADIO
•
•
•
•
RECORDING FROM CD
•
•
•
•
HANDLING COMPACT DISCS
To remove a disc from its storage case, press down on the centre of the case and lift the disc
out, holding it carefully by the edges.
Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft
cloth. Unlike conventional records, compact discs have no grooves to collect dust and
microscopic debris so gently wiping with a soft cloth should remove most particles. Wipe in
a straight line from the inside to the outside of the disc. Small dust particles and light stains
will have absolutely no effect on reproduction quality.
8
English
This unit has Automatic Level Control circuitry. This means that the recording level is
set automatically. The volume or tone controls will not affect the recording.
Record Key will not be pressed down when the record prevention tab is broken or
removed from the tape.
Press the Function Button (20) to select TUNER function.
Tune in your station and put in your cassette tape.
Press the Record Key (
) and the Play Key ( ) at the same time to start recording.
Press the Stop/Eject Key when finished.
Press the Function Button (20) to select CD function. Press the CD Open/Close Button
(18), insert a disc and close CD compartment by pressing again the CD Open/Close
Button (18).
Press the Pause key (II)) then press the Record Key (
same time.
Press the CD Play / Pause button (9) and immediatly repress the Pause key ( II)).
To stop recording, press the Stop button (14) of the CD player. Then press the Stop / Eject
button of the cassette deck.
) and the Play Key ( ) at the
Need help?
Do you have a question about the HIF-6880USMPT and is the answer not in the manual?