Table of Contents
Advertisement
Axion / 150Z Series
Quick Setup List
Page
Setup Procedure
7
Uncrating
8
Battery Activation &
Installation
9-13
Mower Assembly
14
Check Fluid Levels
15
Lubrication
16
Burnish PTO Clutch
16
SAFETY CHECKS
TP 300-5412---ZT-SN
Steps to Perform
❏ Remove crate & banding.
❏ Place transmissions in ROLL RELEASE position & roll off
skid.
❏ Charge the battery (Note: proceed with other setup steps
while battery is charging).
❏ Install & secure battery.
❏ Install the seat.
❏ Install the seat safety switch.
❏ Set up the ground speed control levers.
❏ Torque the mower blade hardware.
❏ Fill & check Engine oil level.
❏ Reduce & check tire pressures
(Front tires 18-20 psi, rear tires 10-12 psi).
❏ Lubricate all grease & oil points.
❏ Burnish PTO clutch (run for 15 seconds, repeat 10 times) .
❏ Perform SAFETY INTERLOCK SYSTEM CHECK.
❏ Perform MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
6
8/2008
Advertisement
Table of Contents
